Because the viscosity of hydraulic oil varies with temperature (as do the clearances between a valve's moving parts), the output of a control valve can tend to drift with temperature changes, temperature compensators adjust the control orifice openings to correct the results of viscosity changes caused by fluid temperature variations.
Flow control valves regulate the flow of oil through the circuit in one direction while allowing free flow in the opposite direction using a control valve.
P. MITSIS SA specializes in oil pressure systems as the Company dates back to 1972 which can provide solutions and understand your needs which will allow you to meet the increasingly difficult challenges we all face.
The hydraulic products are used by genuine equipment manufacturers active in various sectors, such as shipping constructions, underwater works.
The demanding operation of machinery manufacturing systems and hydraulic units needed to improve productivity and performance have made us gain a technical advantage over the competition by developing a range of products and services.
Cetop 3 (Ng6) High Pressure Oil Solenoid Valves.
Maximum Pressure: 315 Bar
Maximum Supply: 80 Liters
Hydraulic high pressure oil proportional valve with feedback. 0-24v
Maximum Delivery 60 Litres/minute
Max Pressure 315 Bar
Analog supply regulator for adjusting the speed of hydraulic cylinders with absolute precision. Possibility of ordering with or without an electronic card. This regulator only has an analog command, not a manual one. When changing the speed of the hydraulic oil, the card has the ability to send information about the speed. so that we change several preset speeds in the same movement of the hydraulic cylinder.
The inset hydraulic cetop regulating valves are required to regulate the flow and therefore also the speed, pressure regulation (safety) single or double, pressure reduction valves, inset sequence valves, inset overcenter valves to balance the acceleration, but also non-return valves. Finally, there is also an inset valve for speed change with electric command and independent pressure regulator CETOP 3 & CETOP 5
All the following valves are (CETOP3 -CETOP5 (NG6-NG10)
Insert Valve Provision Setting
Hydraulic pressure valves for mounting between solenoid valve blocks. In this way, each solenoid valve, i.e. each cylinder, will have its own pressure setting.